Guide

How to load a project and samples onto the Torso S-4

Copy a SynthyCraft project to the S-4 over USB and open it. About five minutes, no extra software.

What you need

  • A Torso S-4 and the USB-C cable that came with it.
  • A Mac or PC.
  • The project ZIP from your Gumroad download page.

What is in the download

Unzip the file. Inside are two things: a folder ending in .s4project, which is the project itself, and a SAMPLES folder with one folder of loops in it. The project points to those loops, so both go onto the S-4.

Put the S-4 in Mass Storage mode

  1. 1Save the project that is open on the S-4, then connect it to the computer.
  2. 2Press CONFIG, turn SELECT to SYSTEM and open it.
  3. 3Choose USB MASS STORAGE. The S-4 shows up on the computer as a drive called S-4.

Copy the files

  1. 1Copy the .s4project folder into the projects folder on the S-4.
  2. 2Copy the folder inside SAMPLES into the samples folder on the S-4. Keep its name as it is.
  3. 3Eject the S-4 from the computer. It disconnects and restarts.

Open the project

  1. 1Press PROJECT, then LOAD.
  2. 2Pick the project from the list with SELECT, and press SELECT again to load it.
  3. 3Play the first scene. Each track already holds its loop, in tempo and in key.

Good to know

  • The S-4 reads WAV and FLAC files at 8, 16, 24 or 32 bit and converts them to 48 kHz inside.
  • A file name that contains a tempo, such as 120bpm, sets the tempo when the sample loads. Most SynthyCraft loops carry their tempo in their name.
  • To make your own projects on a Mac and send them to the S-4, the Creator in S-4 Studio prepares samples and scenes and exports a project the S-4 opens.

Next